Gmi Pro
CB Mic Wiring to Phono Plug?
i've got an old shure 100 series cb mic that i want to use for recording and am having trouble.
there are four wires, 2 of them are for the PT and not necessary for use, so i've got 2 wires, 1 hot and 1 ground i assume.
i've wired it up to a phono plug, but it doesn't work unless i actually touch the mic element. it's like it's using me as a ground. i'm testing out of the case, which is metal.
not sure what's happening, but, herer's a pdf. that shows the circuit diagram at the bottom.
http://www.shure.com/stellent/groups/public/@GMS_GMI_WEB_UG/documents/web_resource/us_pro_101c_ug.pdf
any help is greatly appreciated.
You didn't say if you were recording into a computer, or into audio gear.
According to the pdf, that mike has a carbon granule microphone element, which is commonly used in old telephones and older radio equipment. See:
http://www.aerialpursuits.com/comms/mikes.htm
Now, computers use Electret Condenser mikes, and Pro Audio uses condenser or other more advanced mike designs, which will put out very low levels of sound, typically in the few-millivolt range or less. They require a pre-amp for most applications - a computer sound card has the preamp built in. However, the carbon mike requires an external voltage to power it, a little like an electret, and its output voltage is a significant percentage of the input voltage (so, if you put 5 volts through the carbon mike, your output signal will be about 5 volts max). This means that the CB mike you are using needs an external power source, and its signal will be way higher than your average microphone.
Check out this guy's article. He used a mike from an old telephone, but it's the same type of mike you have from your CB:
http://www.instructables.com/id/Telephone-Handset-Microphone/
His solution involves adding a single battery (1.5 volts), adding a few resistors to bring that voltage down, and feeding the resulting signal to the line-in jacks rather than the mike jack (since the signal will be about 1 volt or so from the mike, and that's closer to line levels than mike levels. I think if you added his solution to your mike, it should work.
As for why it works when you hold it... I think your body may have been supplying a few millivolts to the mike, and this was enough to let the mike generate an output of a few millivolts, which is fine for a mike-input jack, but probably less than what you need to get sound from that mike. Maybe you can experiment with the mike-power that comes from the PC sound card, or tap a USB cord to get 5 volts, apply that voltage to the mike, and use resistors to bring it down to line levels. If you have access to Phantom Power, you can try the same thing. The pdf mentions the current specs that the CB mike takes, so use that as a guide to powering up the mike.
 GMI PRO HYBRID HB3750 3750w 72 CHANNEL RECEIVERUSBSD CARD REMOVALE EARS  US $255.02
|
| Powered by phpBay Pro |
 |
Genie Intellicode Mini Keychain Remote GIT390-4(See Tech. Details Below)
 |
DescriptionOlder transmitters and receivers(prior to 1997) will NOT work with these new electronics. There are no Security Code Switches inside the Door Operators, Transmitters, and Receivers. Features
|
 |
Genie Gwkic Garage Door Opener Keypad Intellicode Opener
|
DescriptionGenie INTELLICODE Keypad garage door opener wireless keypad This keypad will operate up to three (3) doors, 390 MHZ Frequency with code rotating Intellicode format. The Genie keypad model GWKIC offers secure garage entry without using a remote control or key... Features
|
 |
GearWrench (KDT84901) 28 PIece 1/4" Drive 6 Point Metric Standard and Deep Impact Socket Set
List Price: |
DescriptionChrome Molybdenum Alloy Steel for exceptional strength and long lasting durability High visibility laser etched markings with additional hard stamping on the opposite side Surface drive technology Pin hole available for use with pin and o-ring for secure socket retention Sockets come packaged in a reinforced molded case with sizes marked for quick identification and storageCase has reinforced steel hinges and buckles for added durability, security and strength... Features
|
 |
HP Q5942X LaserJet Smart print cartridge (42X)
List Price: |
DescriptionPrinter Supplies, Hewlett Packard, Black Print Cartridge with Smart Printing, Q5942X Features
|
 |
Gemini HSL10 Combo Headset Mic W/ Detach Laval
|
DescriptionConvertible, lightweight headset / Foam wind & pop control inserts / Padded non-slip face rest / Flexible headband to fit most sizes / Easy grip clip Features
|
 |
Gemini DJX-03 On-Ear Professional DJ Headphones
List Price: |
DescriptionGemini DJX-3 Professional DJ Headphone DJX03 Headphones & Earphones Features
|
 |
Gemini DJX-05 Over-Ear Professional DJ Headphones
List Price: |
DescriptionThe Gemini DJX-05 DJ Headphones bring high fidelity sound to your ears, with dynamically enhanced audio in a lightweight and comfortable design. Dynamically enhanced audio in a lightweight and comfortable design... Features
|
 |
Giant Microbes Sperm Cell (Spermatozoon) Plush Toy
List Price: |
DescriptionOur little man's man is the stuff of legends. You can bank on it. Features
|
Uhf Dual
Xlr Cables
Dual Wireless
Professional Microphone
Ribbon Microphone
Microphone Akg
Stereo Pair
Condenser Microphones
Hughes Kettner
Microphone Mic